Paradyne COMSPHERE 3000 Series Installation Manual page 47

COMSPHERE 3000 Series Carrier
2. To install the speaker to the cabinet's front
mounting rails, first determine if you want to
mount the speaker panel above or below the
carrier. Then, fasten one of the speaker panel
mounting brackets to a front mounting rail with a
# 10 Phillips-head screw (supplied). See
Figure 3-13.
NOTE
If your cabinet has unthreaded rails,
first attach a speed nut to the rail hole
you intend to use. Then, fasten a
bracket to the mounting rail using a
supplied #12 screw (the longer
Phillips-head screw).
Figure 3-13. Models 3811/3911 Speaker Panel Installation Directly to Cabinet Rails
3-20
3. Verify that this is the position in which you want
to mount the panel by holding the panel against
the bracket and aligning the panel's captive screws
with the bracket's screw post. (For appearance,
you can adjust the bracket's position to eliminate
space between the speaker panel and carrier.)
If necessary, loosen the bracket and make any
necessary adjustments.
4. Fasten the second speaker panel bracket to the
other mounting rail to match the first bracket's
position.
December 1994 3000-A2-GA31-80