Index - National Instruments 6527 Series Programmer's Manual

Index

Numbers
6527 device
change notification option, 1-2
digital filtering option, 1-2
general operation registers, 1-2
overview, 1-1
PCI interface, 1-1
C
change notification, programming, 3-7 to 3-8
configuring interrupt generation, 3-7 to 3-8
disabling, 3-8
handling interrupts, 3-8
change notification registers
Change Status Register, 2-9
Falling-Edge Detection Registers
(Ports 0–2), 2-13
Master Interrupt Control Register,
2-10 to 2-11
register address map (table), 2-2
Rising-Edge Detection Registers
(Ports 0–2), 2-12
using the change notification option, 1-2
Change Status Register, 2-9
Clear Register, 2-6
ClrEdge bit, Clear Register, 2-6
ClrFilter bit, Clear Register, 2-6
ClrInterval bit, Clear Register, 2-6
ClrOverflow bit, Clear Register, 2-6
configuring interrupt generation, 3-7 to 3-8
conventions used in manual, viii
customer education, A-1
© National Instruments Corporation
D
digital filtering registers
Filter Enables (Ports 0–2), 2-8
Filter Interval Registers, 2-7
overview, 1-2
register address map (table), 2-1
digital I/O circuitry, programming, 3-5 to 3-8
change notification, 3-7 to 3-8
configuring interrupt generation,
3-7 to 3-8
disabling, 3-8
handling interrupts, 3-8
input, 3-5 to 3-6
with filtering, 3-6
output, 3-6
documentation
about this manual, vii
conventions used in manual, viii
how to use manual set, vii
E
EdgeIntEnable bit, Master Interrupt Control
Register, 2-11
EdgeStatus bit, Change Status Register, 2-9
F
Fall<7..0> bits, Falling-Edge Detection
Registers (Ports 0–2), 2-13
Falling-Edge Detection Registers
(Ports 0–2), 2-13
FallingEdgeIntEnable bit, Master Interrupt
Control Register, 2-10
I-1 6527 Register-Level Programmer Manual