Index - National Instruments SCXI-1162HV User Manual

Index

A
AC voltages, 3-5
C
cables, custom, 1-5 to 1-6
configuration. See also installation.
connection to MIO-type or DIO-type
DAQ boards, 2-1
factory configuration, 2-1
jumpers
parts locator diagram, 2-4
procedure for changing jumpers, 2-3
rear signal connector, 3-6
supplementary W3
configuration, 2-6
W2 and W3 jumper configuration
for DIO- and MIO-type boards
(table), 2-6
W4, W5, W6, and W7 jumper
configuration for DIO- and
MIO-type boards (table), 2-5
options, 2-1
parallel mode operation, 2-2
serial mode operation, 2-2
custom cables, 1-5 to 1-6
customer communication, x, B-1
D
DAQD*/A signal (table), 3-8
DC voltages, 3-4
DIGGND signal (table), 3-8
documentation
conventions used in manual, vii
customer communication, x
National Instruments documentation
set, ix
organization of this manual, vii
related documentation, ix
© National Instruments Corporation
E
electrical hazards (warning), 3-1
environment specifications, A-1
equipment, optional, 1-4 to 1-5
F
front connector
optically isolated solid-state relay
channels, 3-4
pin assignments (illustration), 3-3
signal descriptions (table), 3-4
input channels, 3-4
sensing AC voltages, 3-5
sensing DC voltages, 3-4
signal connection example, 3-5
to 3-6
signal isolation, 3-5
G
GND signal (table), 3-9
H
hardware installation, 2-6 to 2-7
I
input channels, 3-4
installation. See also configuration.
hardware installation, 2-6 to 2-7
SCXI-1326 terminal block, 3-6 to 3-7
software installation, 2-7
unpacking the SCXI-1162HV, 1-6
Index-1 SCXI-1162HV User Manual