Dpi Characteristics; Environmental Conditions; Installation Space And Operating Space; Support Base - Wega ALE Series Use And Maintenance Manual

Use of the machine without all the installation operations carried
out by Qualified Technical Personnel can result in serious damage
to the equipment and people.
Any action taken on the electronics of the machine when the
machine is still supplied with electrical power automatically
invalidates any guarantee.

DPI characteristics

5.2
During installation of the machine, the following PPE
are required:
Mandatory use of protective gloves
Mandatory use of eye protection
Mandatory use of protective shoes

Environmental conditions

5.3
5.3.1 Room temperature
The electrical and electronic equipment mounted
on the machine, has been designed and made to func-
tion properly in environments where the temperature is
between +5 and +40 °C.
5.3.2 Relative humidity
The electrical and electronic equipment mounted on
the machine, has been designed and made to function
properly in environments where relative humidity does
not exceed 50% at a temperature of 40 °C, or 90% at a
temperature of 20 °C.
20 68
of

Installation space and operating space

5.4
Before the arrival of the machine, a suitable environ-
ment must be prepared:
Location suited to the intended use and adequate
space for comfortable use of the machine;
adequate lighting, in accordance with applicable
standards;
earthing system compliant with applicable standards;
electrical system compliant with applicable standards;
for machines with gas system, the equipment must
not be installed in environments with volume less
than 12 m 3 , as provided by current standards.

Support base

5.5
To ensure a sufficient degree of ergonomics and safety
to the machine, it is necessary to provide a support base
with the following characteristics:
Make sure that there is sufficient space for placing
and correctly using the machine;
the base should be comfortable and suitable for sup-
porting the weight of the machine(1) and a height of
about 90 cm (19);
the base must be perfectly level and without irregu-
larities;
the base must be in close proximity to the terminals
for the connection to the water mains (15), to the
power supply (9), and, if needed, to the gas main;
if the machine is positioned next to a wall, ensure a
minimum distance of 20 cm between the machine
and the wall (3);
equip the working base of the machine with a drawer
(17) for used coffee grounds, preferably with a rubber
device (18) for tapping the filter holder;
place the motor pump close to the support base,
ensuring the area is free of moisture and away from
accidental contact with the operator.
For correct operation and to ensure safety, the machine must rest
on a perfectly horizontal surface.
Any alignment of the machine must be done by adjusting the
feet (8).
In case of installation of the machine within moving environments
(trains, ships, etc.) it is necessary to use special anchor pins, which
can be bought from the manufacturer, to the base.
TECHNICIANS manual