Sony HAR-D1000 Service Manual page 17

HDD SECTION
Set the HD test mode when performing confirmation (refer to page 11).
After completing confirmation, release the HD test mode.
Note :
If any of the following test modes is executed, data is written in the HD.
Never execute any of these test modes on the customer's HD, because customer's data is erased during test mode.
1. FORMAT
4. WRITE TEST
5. R/W TEST
HD Aging Test
Note (When HD is replaced) :
When HD is replaced, perform the following steps.
(a) When HD is replaced, leave the set with the power on for approximately thirty minutes . (Warming up the HD)
(b) Enter the HD test mode and format the HD.
(c) Turn off the power once and back on again.
(d) Record the music in the HD using CD-HDD Synchro-Recording function for testing the HD. (about thirty minutes)
(e) Confirm that music is correctly recorded. After it is confirmed, erase all recordings on the HD.
1. FORMAT
* This mode performs logical formatting HD. (about three minutes)
If formatting is performed, all data on the HD is erased.
* When HD is replaced, be sure to format the new HD. If the new HD is not formatted, the error message "Format Error " will be displayed.
* The 500 albums and 10 play lists are created at the same time of logical formatting FAT32 on the HD.
Procedure:
(1) Enter the HD test mode, then rotate the
(2) The message "Format Now" is displayed and it takes about three minutes.
(3) When format is complete, "Format End" is displayed.
(4) To exit from this mode, press the
2. FLASH INITIALIZATION
* The last memory (which is stored before power-off) is initialized to the default value of the factory setting.
Procedure:
(1) Enter the HD test mode, then rotate the
(2) Initialization is performed and "OK" is displayed.
(3) To exit from this mode, press the
Contents of the Last memory
Item
S.Space Setup Smart Space ON/OFF
L.Sync Setup Level Syncro ON/OFF
INPUT CD/OPT/ANALOG
L.Sync Th IDX Level-Sync THRESH value
DIG VOL CD CD digital volume dB value
DIG VOL OPT OPT digital volume dB value
DIG VOL ANLG ANALOG digital volume dB value
1/ALL Play mode of ALBUM
PLAY MODE Play mode
REP MODE Repeat mode
Display Mode Time Display mode
Current Album No. The present Album Number
Text Save Setup TEXT SAVE ON/OFF
Sync Mode Setup Normal/High/Changer
[ALBUM]
dial to display "Format?", and press the
[CLEAR]
button.
[ALBUM]
dial to display "Flash Init?", and press the
[CLEAR]
button.
Contents
ON
ON
CD
-50dB
0.0dB
0.0dB
0.0dB
ALL
CONTINUE
OFF
Total playing time
1
ON
Normal
[ALBUM]
[ALBUM]
Default value
HAR-D1000
Ver 1.1 2001.12
dial to display "Format OK?".
dial.
17