Accessing The Hood; Lubrication; Greasing The Machine - Toro Workman MDE 07299 Operator's Manual

Accessing the Hood

Raising the hood
1. Lift up the handle of the rubber latches at each side
of the hood (Figure
Figure 27
2. Raise the hood.
Closing the Hood
1. Gently lower the hood onto the chassis.
2. Secure the hood by aligning the rubber latches onto the
latch anchors at each side of the hood
27).
(Figure

Lubrication

Greasing the Machine

Service Interval: Every 100 hours/Yearly (whichever comes
Grease Type: Number 2 general-purpose, lithium-base
grease
1. Use a rag to wipe the grease fitting clean so that foreign
matter cannot be forced into the bearing or bushing.
2. With a grease gun, apply 1 or 2 pumps of grease into
the grease fittings on the machine.
3. Wipe the excess grease off the machine.
The grease fittings are located at the 4 tie-rod ends
28) and the 2 king pins
27).
1. Grease fitting
1. Grease fitting (king pin)
29
first)—Grease the bearings and bushings.
Grease the machine more frequently
when using it for heavy-duty operations.
(Figure 29).
Figure 28
Left side shown
2. Tie rod
Figure 29
Left side shown
(Figure