Advertisement
LEDs
HMI/Tool
RUN
FLT
8 7 6 5 4 3 2 1
Service button
1
4 / 10
Siemens
Building Technologies
LED
Color
Activity
RUN
Green
• Continuously ON
• Continuously OFF
• Flashing
FLT
Red
• Continuously OFF
• Continuously ON
• Flashing
INF
--
--
COM1
Yellow
• Flashing
COM2
Yellow
• Flashing
SVC
Red
• Continuously OFF
• Continuously ON
• Flashing
• Flashing per wink
command *)
Ethernet
Green
• Continuously ON
1 / 2
• Continuously OFF
• Flashing
Yellow
• Continuously ON
• Continuously OFF
*)
Wink command
pattern:
Button Press
Description
1
• Short
Physical identification on the network (Ethernet).
Proceed as follows to reset the device to a factory state:
1. Power off device.
2. Power on device.
3. Wait for all LEDs to light up and turn off again,
then push the SVC button.
4. Keep SVC button pressed until all LEDs light up, then release.
Up to Desigo V6_SP (FW V01.15.15.144): Keep SVC button
pressed until the green RUN LED flashes, then release.
5. Wait for device to fully start up unconfigured
(RUN LED on, SVC LED flashes).
Any device passwords and other settings are lost.
PXG3...
BACnet router for Ethernet - LONWORKS - MS/TP
Function
• Device ready.
• At least one internal power supply out
of range.
• Start-up of device.
• OK
• HW fault or program fault.
• Incorrect or corrupt FW.
(Not used)
• Sends MS/TP packages.
• Sends L
W
ON
ORKS
(PXG3.L only).
• Configured.
• Defective Hardware.
• Unconfigured.
• Physical identification of the router.
• Link active
• Link inactive
• Network activity
• Link 100 Mbps
• Link 10 Mbps
21s
5 Hz
1s
2s
2s
packages
9222z02
5 Hz
1s
CM1N9270en_10
2017-10-16
Advertisement
