Removing The Stability Foot; Procedure - Alienware Area-51 Service Manual

Removing the Stability Foot

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your
Working Inside Your
regulatory_compliance.

Procedure

1. Tilt the computer towards the front until the base is facing up.
2. Remove the screws that secure the stability foot to the computer.
3. Lift the stability foot off the computer.
a. stability foot
b. screws (2)
c. computer
4. Tilt the computer back to the upright position.
16
Computer. After working inside your computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
After