Removing The Right Alienfx Side-Panel Connector; Prerequisites; Procedure - Alienware Area-51 Service Manual

Removing the Right AlienFX Side-Panel Connector

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your
Working Inside Your
regulatory_compliance.

Prerequisites

1. Remove the stability foot.
2. Remove both the left and right side-panels. See

Procedure

1. Lay the chassis on the left side.
2. Disconnect the cable that connects the right AlienFX side-panel connector to the I/O board. See
3. Remove the screw that secures the right AlienFX side-panel connector assembly to the chassis.
4. Remove the right AlienFX side-panel connector assembly from the chassis.
1. screw
3. AlienFX side-panel cable
5. Remove the screws that secure the right AlienFX side-panel connector to the bracket and set it aside in a secure location.
32
Computer. After working inside your computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
"Removing the Side Panels".
2. right AlienFX side-panel connector assembly
4. AlienFX side-panel connector
After
"I/O Board Components".