Table of Contents
Advertisement
D
3-2
RIp
5. Ensure that drip piping is supported to
relieve any stress on drip pipe connectors and
drain hub.
a. Drip piping MUST be supported no
more than 24 in. from drain hub tee.
Bottom of Case
Drain Hub Tee
Drip Piping
Support Here
24 in.
It is the installing contractor's
responsibility to consult local agencies for
local code requirements.
Always Slope Toward Floor Drain
Bottom of Case
One Water Seal per Run of Drip Pipe
P/N 0515388_K
p
s
IpIng anD
plashguaRDs
Drain Hub
Drip Piping
Support Here
24 in.
Slope
Optional Excel Drip Piping Arrangements
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
6. Provide a suitable air break
between flood rim of the floor drain
and outlet of drip pipe. To meet code
on low base merchandisers, it may be
necessary to install a field-supplied
drip pipe reducer. An alternative is to
cut the last section of drip pipe at an
angle (where permissible by code).
7. Prevent drip pipes from freezing:
a. Do NOT install drip pipes in contact
with uninsulated suction lines. Suction lines
should be insulated with a nonabsorbent
insulation material.
b. Where drip pipes are located in dead air
spaces, such as between merchandisers or
between a merchandiser and a store wall,
provide means to prevent freezing.
Bottom of Case
Slope
Bottom of Case
Advertisement
Table of Contents
