Base I/O Address Settings; Figure 2-1. Pc-Tio-10 Parts Locator Diagram - National Instruments PC-TIO-10 User Manual

Configuration and Installation

Base I/O Address Settings

The base I/O address for the PC-TIO-10 is determined by the switches at position U12 (see
Figure 2-1). The switches are set at the factory for the I/O address hex 1A0. With this default
setting, the PC-TIO-10 uses the I/O address space hex 1A0 through 1A7.
Note: Verify that this space is not already used by other equipment installed in your computer.
If any equipment in your computer uses this I/O address space, you must change the base
I/O address for the PC-TIO-10 or for the other device.
PC-TIO-10 User Manual

Figure 2-1. PC-TIO-10 Parts Locator Diagram

2-2 © National Instruments Corporation
Chapter 2