Advertisement
Table 4. Events for the Enclosure component (continued)
Event
current_ok
current_warn
dcm_drawer_open
dcm_failed
dcm_not_available
dcm_ok
drawer_failed
drawer_ok
drive_firmware_notavail
drive_firmware_ok
drive_firmware_wrong
enclosure_data
enclosure_firmware_notavail
enclosure_firmware_ok
enclosure_firmware_unknown
Event Type
Severity
STATE_CHANGE
INFO
STATE_CHANGE
WARNIN
G
STATE_CHANGE
WARNIN
G
STATE_CHANGE
WARNIN
G
STATE_CHANGE
WARNIN
G
STATE_CHANGE
INFO
STATE_CHANGE
ERROR
STATE_CHANGE
INFO
STATE_CHANGE
WARNIN
G
STATE_CHANGE
INFO
STATE_CHANGE
WARNIN
G
STATE_CHANGE
INFO
STATE_CHANGE
WARNIN
G
STATE_CHANGE
INFO
STATE_CHANGE
WARNIN
G
Message
Description
currentSensor {0}
The currentSensor
is ok.
state is ok.
currentSensor {0}
The currentSensor
is degraded.
state is degraded.
DCM {0} drawer is
The DCM drawer is
open.
open.
DCM {0} is failed.
The DCM state is
failed.
DCM {0} is not
The DCM is not
available.
installed or not
responding.
DCM {id[1]} is ok.
The DCM state is
ok.
drawer {0} is
The drawer state is
failed.
failed.
drawer {0} is ok.
The drawer state is
ok.
The firmware level
The firmware level
of drive {0} is not
of the drive is not
available.
available.
The firmware level
The firmware level
of drive {0} is
of the drive is
correct.
correct.
The firmware level
The firmware level
of drive {0} is
of the drive is
wrong.
wrong.
Enclosure data
Successfully
found.
queried the
enclosure details.
The firmware level
The firmware level
of enclosure {0} is
of the enclosure is
not available.
not available.
The firmware level
The firmware level
of enclosure {0} is
of the enclosure is
correct.
correct.
The firmware level
The SAS card is
of enclosure {0} is
unable to read
unknown.
enclosure
firmware.
Cause
User Action
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Check the installed
firmware level using
the mmlsfirmware
command.
N/A
N/A
N/A
Check the installed
firmware level using
the mmlsfirmware
command.
The
N/A
mmlsenclosure
all -L -Y
command reports
enclosure data.
N/A
Check the installed
firmware level using
the mmlsfirmware
command.
N/A
N/A
The SAS card does
Check the SAS
not report the
connectivity from
enclosure
node to enclosure.
firmware.
Use the
mmlsrecoverygrou
p rg_name -L --
pdisk command to
verify if all the paths
to pdisk are
available. Check the
SAS connectivity
using a combination
of the
mmgetpdisktopolo
gy and the
topsummary
command. If there is
an issue with the SAS
HBA or SAS Cable,
reboot the node to
see if this resolves
the issue. If not
contact your IBM
representative.
Chapter 1. Events 5
Advertisement
