Detroit Diesel MBE 4000 DDEC VI Troubleshooting Manual page 398

47.2 SPN 609/FMI 14
47.2 SPN 609/FMI 14
This diagnostic condition is typically MCM incorrectly programmed.
47.2.1 MCM Check
Check the MCM as follows:
1. Check to ensure the MCM is correct for the engine.
[a] If MCM is correct for the engine, go to step 2.
[b] If MCM is not correct for the engine, contact Detroit Diesel Customer Support
Center (313–592–5800) for authorization to replace the MCM. Set parameters on
the new MCM.
2. Reset the MCM parameters.
[a] If fault code 233/14 is not active after the MCM parameters are reset, troubleshooting
is complete.
[b] If fault code 233/14 is still active after the MCM parameters are reset, go to step 3.
3. Check the MCM parameters to ensure they are correct for the vehicle configuration.
[a] If the MCM parameters are not correct, reset the parameters.
[b] If the MCM parameters are correct, contact Detroit Diesel Customer Support Center
(313–592–5800) for authorization to replace the MCM. Set the parameters on the
new MCM.
47-4
6SE568 Copyright © PRELIMINARY 2007 DETROIT DIESEL CORPORATION
(Rev. ) All information subject to change without notice.