17.2.2
Connector Brackets
The harnesses on MCM must be bracketed and held secure. The bracket design will change for
different engines as the routing is different. The 120–pin connector and the 21-pin connector
must be tie-wrapped to the brackets as shown in the following drawing for the MBE engines
(see Figure 17-2).
Figure 17-2
MBE 4000 120–pin Connector and 21–pin Connector Tie-wrapped
to Brackets
All information subject to change without notice.
6SE568
Copyright © PRELIMINARY 2007 DETROIT DIESEL CORPORATION
(Rev. )
MBE 4000 DDEC VI TROUBLESHOOTING GUIDE
17-9