Activating Adaptive Cruise Control (Acc); To Activate/Deactivate; To Set A Desired Acc Speed - Dodge DURANGO 2020 Owner's Manual

204 STARTING AND OPERATING
A A C
CTIVATING DAPTIVE RUISE
(ACC)
You can only engage ACC if the vehicle speed is
above 0 mph (0 km/h).
The minimum set speed for the ACC system is
20 mph (32 km/h).
When the system is turned on and in the ready
state, the instrument cluster displays "ACC
Ready."
When the system is off, the instrument cluster
displays "Adaptive Cruise Control (ACC) Off."
NOTE:
You cannot engage ACC under the following
conditions:
When in Four-Wheel Drive Low

When you apply the brakes

When the parking brake is applied

When the automatic transmission is in PARK,

REVERSE or NEUTRAL
When the vehicle speed is outside of the

speed range
When the brakes are overheated

C
When the driver's door is open at low speeds
ONTROL 
When the driver's seat belt is unbuckled at

low speeds
ESC Full Off mode is active

T A /D
O CTIVATE
Push and release the Adaptive Cruise Control
(ACC) on/off button. The ACC menu in the
instrument cluster displays "ACC Ready."
Adaptive Cruise Control Ready
To turn the system off, push and release the
Adaptive Cruise Control (ACC) on/off button
again. At this time, the system will turn off and
the instrument cluster displays "Adaptive Cruise
Control (ACC) Off."
EACTIVATE
Adaptive Cruise Control Off
WARNING!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous. You
could accidentally set the system or cause it
to go faster than you want. You could lose
control and have a collision. Always leave the
system off when you are not using it.
T S A D ACC S
O ET ESIRED
When the vehicle reaches the speed desired,
push the SET (+) button or the SET (-) button
and release. The instrument cluster display will
display the set speed.
If the system is set when the vehicle speed is
below 20 mph (32 km/h), the set speed shall
PEED