Radio Reception; Storing Stations; Calling Up A Stored Station; Last Station Memory - Grundig PRIMA BOY 100 Manual

Prima Boy 100 page 12

Radio reception

• Switch the radio on and off with the y POWER
button.
– The first time you switch your unit on, the display
indicates 87.5 MHz.
GB
• Adjust the volume with the rotary control VOLUME.
• Pull out the telescopic aerial. To improve FM
reception, incline and turn the aerial. Reduce its
length if the FM signal is too strong (very close to
a transmitter).
Automatic tuning
• To activate automatic station search (
), press + or – until the frequency display
TUNING
begins 'to run'; then release the button.
– The search stops as soon as a station is found
and tuned to.
– Stations which are received with a weak field
strength may be skipped.
These can be tuned to manually.
Manual tuning
• Briefly press the + or – button to tune in the
corresponding direction in individual steps.
– The dot in front of the frequency indicates 50
kHz steps (e.g. 100.55).
• If you keep the button depressed, you can
rapidly scan large frequency ranges.
– When you release the button,
automatically switched to.
• If you briefly press one of the + or – buttons,
manual tuning is switched to.
12
AUTO
is
AUTO TUNING
RADIO
There are 10 memory locations available for

storing stations.

• Tune to the station you want to store.
• Press MEMO.
– The indication 'M' starts flashing on the display
M
• Press the number (PRESETS 1...5) you want to
– If you want to assign the station to memory
M
➥
• Press MEMO again to store the station.
• Select and store in this way all desired stations.
Note:
If no station is stored within the 5 seconds that 'M'
is flashing, the storing mode is abandoned with no
change to the current memory.
• To call up a stored station, simply press the
– If you call up a station which is assigned to
– The unit switches to the station and the display
M
Your unit is provided with the function '
MEMORY
playing when the set was switched off will be
selected again when the unit is switched back on.
Storing stations
for 5 seconds.
assign the station to.
location numbers 6 to 10, press MEMO, then
+5, then the appropriate number button.

Calling up a stored station

corresponding button.
memory location numbers 6 to 10, first press +5,
then the appropriate number button.
indicates the frequency, 'M' and the memory
location number.

Last Station Memory

', which means that the station that was
LAST STATION