TRENDnet User's Guide
2. Select All Day or Customized schedule of the
day.
3. Set the time period and the event you want
to trigger the video recording continuous
(always recording) or motion detection.
4. Click Select All or the weekday you want to
have the same schedule on different day.
5. Click another day of the week by clicking on
its tab to set the next schedule. Click OK
when you have finished your settings.
Normal Linkage / Network Storage
Send Email: Check this box to send an e‐mail notification when
motion is detected.
Upload to
Check this box to send snapshots to an FTP server
FTP/Memory
or the installed SD card when motion is detected.
Card:
Network
You may select your configured network storage
Storage:
drives can be found here.
Click Save to save the changes
© Copyright 2018 TRENDnet. All Rights Reserved.
Video Tampering
This is to detect if the camera has been tampered with and surveillance is
compromised. You can set up tamper proof notifications to alert the system
manager to check the camera.
Enable
Check this box to enable tamper detection. Click Save
Tamper
to save the settings.
Detection:
Draw Area: Click Draw Area button to start drawing. Click and drag
on the area you want to set up the tamper detection.
You can setup only one area for tamper detection.
Click Stop Drawing to stop drawing motion detection
areas. The gray block represents the detection area.
Sensitivity: Move the slider to adjust detection sensitivity.
Clear All: Click this button to clear all the set up areas.
TV‐IP323PI
44