Advertisement
d. Attach the Camera Body to the Base Plate. Screw back the Fix Screw.
Fix Screw
3. Connect the Power Cable to a 12VDCpower source. Connect the Video
Output Cable to a monitor or DVR.
4. You can use the Joystick on the cable to configure camera OSD settings.
Remove the Protection Cap from the Joystick before using it.
5. You can optionally adjust the camera angles. To do so, unscrew the 4 cover
screws using the supplied L-Type Wrench and then remove the cover. Adjust
the camera angles (Tilt: 60°, Pan: 350°, Rotate: 350°). After adjusting camera
angles, screw back the camera cover.
Base Plate
Camera Body
Configuring OSD Settings:
Push the Joystick up / down to select among
•
menu items.
Push the Joystick left / right to adjust the level of
•
the selected item.
Press the Joystick to enter the submenu or exit
•
the OSD Setup Menu.
60°
350°
350°
4
Advertisement
