Advertisement
2. To mount the camera to the surface:
a. Remove the Base Plate from the camera. To do so, 1) Remove the Fix
Screw 2) Slightly push the Base Plate backward from the Fix Screw side
and then pull out the Base Plate. Screw the Base Plate to the surface using
the supplied 4 Screws.
Push
b. Open the Camera Cover to remove the old desiccant bag from the Camera
Body and stick the supplied Desiccant Bag inside the Camera Body. It's
highly recommended to replace the desiccant bag every time when you
open the Camera Cover.
c. For the first time installation, check whether the camera is properly
focused. If not, you can optionally adjust camera zoom and focus by
adjusting the Zoom Screw or Focus Screw using a slotted screwdriver.
Zoom Focus
Pull
Base Plate
Fix Screw
Note: Please screw back the Camera
Cover immediately in case of reducing
the absorption capacity of the desiccant
bag inside the camera body.
3
Base Plate
Screws
Advertisement
