Getting Started; Battery Installation - VTech Toot-Toot Drivers Parents' Manual

GETTING STARTED

BATTERY INSTALLATION

Race Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the Race Car. Use a screwdriver to
loosen the screw.
3. If used or spent batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
5
5
5