VTech Toot-Toot Drivers Press ‘n’ Go Vehicle User Manual

Toot-Toot Drivers
User's Manual

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the
unit. Use a screwdriver to loosen the screw.
3. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy, and
should be discarded for your child's safety.
NOTE:
Please keep this user's manual as it contains important
information.
Unlock the packaging locks:
Turn the packaging lock anticlockwise
several times.
Pull out and discard the packaging lock.
WARNING: For your child's safety, do not press and release the
vehicle on clothing, body or hair.
Press 'n' Go Vehicle
®
91-003299-009
1

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if removable).
• Rechargeable batteries are only to be charged under adult supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries, or
on their respective packaging, indicates they must not be disposed of
in domestic waste as they contain substances that can be damaging
to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate that
the battery contains more than the specified value of mercury (Hg),
cadmium (Cd) or lead (Pb) set out in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the market
after 13th August, 2005.
Help protect the environment by disposing of your product or batteries
responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com

PRODUCT FEATURES

1. ON/OFF SWITCH
To turn the unit ON, slide the ON/OFF
SWITCH to the ON ( ) position. To turn
the unit OFF, slide the ON/OFF SWITCH to
the OFF (
) position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech
will automatically power down after approximately 60 seconds without input.
The unit can only be turned on again by pressing the LIGHT-UP BUTTON,
pressing down on the vehicle or pushing the vehicle quickly.
NOTE: If the unit powers down while playing, we suggest changing the batteries.
Toot-Toot Drivers Press 'n' Go Vehicle
® ®
2