General Wiring Schematic For The Cp04; Wiring The Dust Level Sensor To The Cp04; Wiring The Microswitch To The; System Interlock Via The Cp04 - Boss EcoMAXX EM-NRV Series Supplemental Manual

General Wiring Schematic for the Cp04 (56004-031103)

Wiring the Dust Level Sensor to the CP04

Connect the brown wire to terminal 4.1 on
the intrinsic relay barrier. Connect the blue
wire to terminal 4.3 on the intrinsic relay
barrier.
Wiring the Microswitch to the CP04
Similar to the CP03, the black wire will land in the "24V+"
terminal and the gray wire will land in the "1" terminal.
Disregard all other wires from microswitch. (See below)
Jumper will be required between "24V+" and "2" (See
Below)
Microswitch Connections
Terminals "U1" and "U2" will be used as a shut-
down signal in the CP04. When the CP04 is "OK"
the interlock contact will be closed. The contact
will open if any sensor faults. (Refer to above sche-
matic)
Jumper Connections
(Unless Using Clean Side Vigiflap)
NRV NA Sup. Manual 2020 - Second Edition - Version 0020
Print date: 6/26/2020
System Interlock Via CP04
interlock Connections
Page 18