Siemens NK8000 MP.4.60 Installation Function & Configuration Commissioning Safety Regulations page 71

Building Technologies
Fire Safety & Security Products
Reads current settings of date and time from the NK8000 RTC.
Read CPU ID
Reads the CPU ID from the DIMM-PC module on NK822x.
Read Product ID
Reads the Product ID from the NK82xx. The Product ID is used to distinguish between
NK8222, NK8223, and NK8225.
Read HW Conf. ID
Reads the HW Configuration ID from the unit. The HW Conf. ID is used to check the
HW Configuration from a remote location:
Serial:

– NH8002 (NK822x) serial port add-on board installed.
– NKA8001-A1 or NKA8001-A2 (NK823x) serial port add-on board installed.
LON: NH8010 PC-104 LON add-on board installed (NK822x).

Serial + LON: NH8002 + NH8010 installed (NK822x).

Read Memory
Displays the amount of RAM (in bytes) available on the NK8000.
Note: This functionality is not available in the NK8000 Web Server NS8210 tool.
Read Connected IP
Reads the IP address of the last host PC that was connected to the selected port.
Note: This functionality is not available in the NK8000 Web Server NS8210 tool.
Pressing this button causes the following dialog box to display:
Port number request
Possible port numbers are 3001, 3002, 3003, 3004, and 4000 (CMSDL/IP) or 47808
(BACnet).
Click OK to check the port number. At that point, the associated field shows the type of
information found (e.g. Last IP connected) and you can to use the field arrow controls
to show the actual IP address.
Note: If the IP address shows '0.0.0.0', no PC was connected to that port.
Read HW version
Reads the NK823x hardware version (NKM8001-A1, NKM8001-A2, ...).
Maintenance and diagnostics
The NW8204 maintenance and diagnostic tool
9
71
A6V10062437_a_en
30.06.2013