Demonstrating authentication
Confirming that the wireless access points are activated
Viewing the profile-based configuration
12
Check each FortiAP unit to see that the Power, Port 0, and Wireless LEDs are all lit green.
This can take up to five minutes after the APs are enabled. On the FortiGate unit, go to
Wireless Controller > Configuration > Access Points and check that the Status of both APs
is Connected.
Go to Wireless Controller > Configuration > AP Profile and select the Demo-profile.
Note the selection of Platform (Access Point) type, Band, Channels. These will all apply to
the Virtual APs that you select.
FortiAP™ Wireless Starter Kit
Wireless Starter Kit Guide for FortiOS 4.0 MR2
01-420-139115-20110223
http://docs.fortinet.com/
•
Feedback