Table of Contents
Advertisement
Notice: To ensure an effective flush performance,
strongly recommended inner diameter of
water supply (including water meter, valve, etc.)
is no less than 25mm, and supplied water
pressure (sensor inlet dynamic pressure) is
0.18MPa ~0.55MPa.
PREPARE THE SITE
PREPARE THE SITE
NOTE:
If a pre-existing waste pipe will be used and will result
in an acceptable rim height (refer to the rough-in dimensions),
follow the retrofit installation instructions.
For Retrofit Installations
!
Turn the water supply line off, remove the existing urinal,
then cap off the water supply line inside the wall.
For New Installations
!
Install waste pipe as necessary to conform to the
roughing-in dimensions.
!
Install adequate support framing for the hangers as
needed.
INSTALLATION
A. Install hangers, L shape block and waste pipe
connector
Drill holes according to template. Install hangers, L shape
block and waste pipe connector. (Gasket of waste pipe
connector shall be soaked into water for 2 seconds to
lubricate.)
Wall Hangers
1237458-T01-A
Wall
Wall
35
)
)
!
!
!
Drain Connection
Fig.2
2
A.
L
(
Insert the connector into the waste
pipe in the wall along this direction.
Pre-installed waste
pipe connector
Fig.3
3
-3-
(
25mm
) 0.18MPa ~0.55MPa
Wall
Wall Hangers
L
Move the gasket to front
of the pipe before
connecting to the urinal.
(
(
)
Advertisement
Table of Contents
