Configure The Device; Ethernet Setup - Crestron DGE-100 Supplemental Manual

Configure the Device

Refer to the following sections for information about each DGE setup screen.

Ethernet Setup

Tap Ethernet Setup on the Setup screen to display the Ethernet Setup screen.
Ethernet Setup Screen
Use the Ethernet Setup screen to view the DGE MAC and IP addresses, subnet mask
address, default router address, primary and secondary DNS addresses, hostname, and
domain. A Link indicator is provided to indicate the status of the Ethernet connection.
(Green indicates that the Ethernet connection is active.)
The following buttons are provided for configuring Ethernet settings:
Tap On or Off under DHCP Enabled to turn DHCP (dynamic host configuration
•
protocol) on or off.
NOTE:
If DHCP is turned off, tap Set Static IP Address Settings to enter static IP
•
addresses manually.
Tap Set Hostname to enter a new DGE hostname using an on-screen keyboard.
•
Tap Apply Changes to apply any new Ethernet settings to the DGE and to stay in
•
setup mode.
Tap Reboot to exit setup mode and reboot the DGE.
•
Supplemental Guide – DOC. 7696C
DHCP is enabled on the DGE by default.
DGE-100/DM-DGE-200-C: Digital Graphics Engines • 5