User Interface; Disabling The Af Gain Control From The Arcp-990; Lan Connection With The Ts-990S; Internal Voip (For The Kns Connection Via A Lan) - Kenwood TS-990S In-Depth Manual

Hide thumbs Also See for TS-990S:

Table of Contents

07 SOFTWARE

User Interface

The ARHP‑990 has its user interface languages in both Japanese and English. The ARHP‑990 is operable with the

language familiar to the user.

The ARHP‑990 can automatically start up when Windows starts. With this function, for instance, when a PC restarts, the

ARHP‑990 automatically starts up and establishes a connection.

Select "Settings" from the "Tool" pull‑down menu, and then click on the "Run Automatically at Windows startup."

checkbox to enable it.

Now, operating statuses of the ARHP‑990 and TS‑990S can be viewed even while the ARHP‑990 is minimized.

The TS‑990S power On/Off state, user connection status, transmitting state, etc. can be viewed in pop‑up messages.

Disabling the AF Gain Control from the ARCP‑990

In the ARHP‑990, the AF gain control by the ARCP‑990 can be disabled. If the AF gain control can be controlled from

the ARCP‑990, an unexpected audio level may be set in the TS‑990S. Disabling the AF gain control does not change the

audio level.

To enable this function, select "Setup" from the "Tool" pulldown menu, and then click on the "Prohibits control of AF gain

from ARCP‑990" checkbox in the "Settings" screen.

LAN Connection with the TS‑990S

In the ARHP‑990, a connection to the TS‑990S through the LAN connector is implemented. Refer to the section "LAN

Connection with the TS‑990S" in "Radio Control Program ARCP‑990".

For the VoIP functions, refer to "Internally Implemented VoIP (for a LAN connection to the KNS)" in "Radio Control

Program ARCP‑990".

Fig. 123 ARHP‑990 Pop‑up Message

Table of Contents