Various Software Applications For Extensive Operations - Kenwood TS-990S In-Depth Manual

07 SOFTWARE

Various Software Applications for Extensive Operations

This section describes the software to control the TS‑990S from a PC which has Windows installed.
The software listed below is available to control the TS‑990S.
Name
ARCP‑990
ARHP‑990
ARVP‑10
ARUA‑10
Virtual COM Port
Driver
The software applications listed above can be downloaded from the KENWOOD website free of charge.
http://www.kenwood.com/i/products/info/amateur/software_download.html
74
This is a software application that controls the TS‑990S from the PC.
This is a software application on the host station PC to remotely control the TS‑990S through a
network.
This is to be used together with ARCP‑990.
This is VoIP software to send TX/RX audio signals when a PC is connected to the KNS through the
Internet and the PC remotely controls the TS‑990S.
Note:
◆ There are two types of ARVP‑10: the ARVP‑10H and ARVP‑10R.
◆ These software applications are not used when a PC is connected to KNS through a LAN.
This is a software application to substitute a microphone and speaker of the TS‑990S with the
microphone and speaker of the PC, when the TS‑990S is connected to the PC through a USB cable.
It allows the TS‑990S to transmit audio signals collected by the PC microphone, through the USB
Audio. Also, the output audio signal from the TS‑990S can sound from the PC speaker through the
USB Audio.
Note:
◆ This software is not used when a user‑manufactured audio signal cable is connected to the
ACC2 connector.
◆ This software is not used for a connection through a network.
This is a driver to be installed in the PC, connecting the TS‑990S with a USB cable, to operate the
TS‑990S using the ARCP‑990 or ARHP‑990.
Note:
◆ This software is not used when a serial or LAN cable is connected.
Description