Table of Contents
Advertisement
®
LazerData
11000 Scanner
1.2
DESCRIPTION
Some of the main features of the LazerData
• small size
• scanning speed of up to 600 scans/s
• raster version availability
• serial communication interfaces (one or two)
• readability of all popular codes
• supply voltage range from 10 to 30 VDC
• test mode — for verification of reading features and exact scanner positioning
without need for external tools
• programmability in four different operating modes — to suit the most varied bar
code reading system requirements
• low power consumption
The scanner uses a solid-state laser diode as a light source. The light emitted has a
wavelength between 630 and 680 nm. Refer to the section "Safety Precautions" at
the beginning of this manual for information on laser safety.
With an IP65 protection class enclosure, the reader is suitable for industrial
environments where high protection against harsh external conditions is required.
The four LEDs on the side of the scanner indicate the following:
PWR/TXD
(red) (Figure A.,
supply or, when blinking (green), data transmission.
GOOD READ (red) (Figure A.,
EXT TRIG
(yellow) (Figure A.,
active.
LASER ON
(green) (Figure A.,
The screw holes on the body of the reader are for mechanical fixture (Figure
j
A.,
).
1.2 - General Features
®
11000 Scanner are —
c
) indicates the reader is connected to the power
e
) signals possible, successful bar code reading.
d
) indicates the code presence sensor is
f
) indicates laser ON state.
Installation Manual
Advertisement
Table of Contents
