Weider WESY49310 User Manual page 13

24. See the inset drawing. Attach a 3 1/2" Pulley
(15) and a Cable Trap (66) to the upper hole in
a Long "U"-Bracket (57) with a 3/8" x 2" Bolt
(12) and a 3/8" Nylon Locknut (21). Be sure
that the Cable Trap is inside the Long "U"-
Bracket. Note: This may come pre-assem-
bled.
Route the High Cable (58) through the Long
"U"-Bracket (57) and the 3 1/2" Pulley (15)
shown in the inset drawing. Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.
25. Wrap the High Cable (58) around a 3 1/2"
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with a 3/8" x 2" Bolt (12)
and a 3/8" Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
26. Note: This assembly step shows how to
complete the assembly of several pre-
attached parts.
The 5/8" x 9/16" Spacer (7) has been pre-
attached on the outside of the 3 1/2" Low
Pulley (102) for shipping purposes. Remove
the 3/8" Nylon Locknut (21), the Spacer, and
the Pulley from the 3/8" x 3 3/4" Bolt (88). Do
not remove the Bolt. The Bolt has been
shown removed for part identification.
Reattach the 3 1/2" Low Pulley (102), with the
5/8" x 9/16" Spacer (7) between the Pulley and
the Press Frame (17). Do not tighten the 3/8"
Nylon Locknut (21) yet. Be sure that the
3/8" x 3 3/4" Bolt (88), the 3/8" Flat Washer
(9), the 5/8" x 9/16" Spacer, the 3 1/2" Low
Pulley, and the 3/8" Nylon Locknut are ori-
ented as shown.
24
66
15
21
57
25
Bracket
55
21
26
13
58
15
12
57
58
15
9
88
7
17
102
21
58
12