Assembly - Weider Pro XT20 WEBE09101 User Manual

ASSEMBLY

Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
1. Press a 50mm Square Inner Cap (1) into the indi-
cated end of the Front Leg (19). Insert a 50mm
Thick Inner Cap (35) into the bottom of the Front
Leg.
Attach the Front Leg (19) to the Bench Frame (5)
using two M10 x 65mm Bolts (23), two M10
Washers (6), and two M10 Nylon Locknuts (11).
2. Press a 51mm x 76mm Outer Cap (2) onto each
end of the Stabilizer (24). Attach the Stabilizer to
the Bench Frame (5) using two M10 x 58mm
Carriage Bolts (8) and two M10 Nylon Locknuts
(11).
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
6
11
19
35
1
2
6
23
5
23
11
5
24
2
2
8