Weider 831.15711.0 User Manual page 9

9. Insert a Pad Tube (19) into the Leg Lever (3).
Slide two Foam Pads (20) onto the Pad Tube.
Repeat this step with the other two Pad Tubes
(19) and the Leg Lever (3) and Front Leg (2).
10. Attach the Curl Pad (15) to the Curl Post (11) with
two M6 x 16mm Screws (39).
11. Route the Lat Cable (35) through the Lat Tower
(8) and over the Pulley (38). Make sure that the
Cable is under the lat bar rest. Attach the Pulley
inside the Lat Tower with an M10 x 60mm Bolt
(47), two M10 Washers (44), two 10mm Large
Spacers (31), and an M10 Nylon Locknut (43).
12. Insert an M10 x 19mm Bolt (53) into the bracket
on the Weight Carriage (9).
Slide the Weight Carriage (9) onto the Lat Tower
(8). Make sure that the bracket on the Weight
Carriage and the lat bar rest on the Lat Tower
(see step 11) are on opposite sides of the Lat
Tower. Attach the Lat Cable (35) to the M10 x
19mm Bolt (53) with an M10 Nylon Locknut (43).
13. Make sure that all parts are properly tightened
before the weight bench is used. The use of all
remaining parts will be explained in ADJUST-
MENT on page 10.
9
3
20
10
11
43
44
38
12
35
43
Bracket
35
9
43
33
9
9
2
19
19
20
19
15
11
39
Lat Bar
31
Rest
35
44
31
47
8
8
53
24
53
33