Weider 831.15711.0 User Manual page 7

2. Attach the Bench Frame (1) to the Front Leg (2)
with two M10 x 65mm Bolts (40), two M10
Washers (44), and two M10 Nylon Locknuts (43).
Do not tighten the Nylon Locknuts yet.
3. Attach the Bench Frame (1) to the Crossbar (4)
with two M10 x 81mm Bolts (41) and two M10
Nylon Locknuts (43).
Tighten the M10 Nylon Locknuts (43) used in
steps 1 through 3.
4. Attach the Weight Tube (16) inside the Leg Lever
(3) with an M8 x 58mm Bolt (52), two M8
Washers (56), a 10mm Spacer (32), and an M8
Nylon Locknut (55).
Press the 25mm Round Angled Cap (28) onto the
Weight Tube (16).
Grease an M10 x 68mm Bolt (54). Attach the Leg
Lever (3) with the Bolt and an M10 Nylon Locknut
(43). Do not overtighten the Nylon Locknut;
the Leg Lever must pivot easily.
5. Orient the Backrest Frames (12) with the indicat-
ed tubes in the position shown. Attach the
Backrest Frames to the Backrest Bracket (10)
with four M6 x 40mm Bolts (49), four M6 Washers
(48), and four M6 Nylon Locknuts (51). Do not
tighten the Nylon Locknuts yet.
2
40
44
43
2
3
41
1
4
3
55
32
56
56
16
5
49
48
Tubes
10
7
1
40
4
43
41
43
2
Grease
28
54
52
48
12
12
48
49
48
51
51