Adjusting The Weider Pro 635 - Weider 831.150390 User Manual

ADJUSTING THE WEIDER PRO 635

The weight bench is designed to be used with your own weight set (not included). The steps below explain how
the weight bench can be adjusted. See EXERCISE GUIDELINES on page 14 for important exercise information
and refer to the accompanying exercise poster to see the correct form for each exercise. Refer also to the exer-
cise information accompanying your weight set for additional exercises.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The
weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
Weight
To use the lat tower, first slide a Weight Stop (19) onto
each side of the weight tube of the Weight Carriage (56).
19
Slide the desired amount of weight (not included) onto the
19
34
Weight
weight tube. Be sure that an equal amount of weight is on
Tube
each side of the weight tube. Secure the weights on each
side of the weight tube with a Spring Clip (34).
56
34
Do not place more than 150 pounds on the Weight
Carriage. (Due to the fact that ab crunches are an aer-
obic exercise, we recommend that you do not place
more than 50 pounds on the Weight Carriage while
Weight
performing ab crunch exercises.)
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (28), slide the desired amount of
28
weight (not included) onto the weight tube.
If you are using olympic weights, slide the Olympic
Adapter (58) onto the Leg Lever (28) before sliding any
Weight
weight onto the Leg Lever.
Do not place more than 150 pounds on the Leg Lever.
Weight
58
Tube
ADJUSTING THE BACKREST
36
The Backrest (36) can be set at three different positions:
the level position, the decline position, and the incline posi-
tion.
To change the position of the Backrest (36), remove the
39
"L"-Pin (50) from the Adjustment Bracket (51) and the
Bench Frame (39). Set the Backrest to the desired posi-
tion, align the holes in the Adjustment Bracket and the
Bench Frame, and re-insert the "L"-Pin.
50
51
12