Taurus Ikarus Manual page 18

and finally switching on the appliance
during a few seconds.
- Make sure that the appliance is
serviced only by specialist personnel,
and that only original spare parts
or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow
the instructions for use renders the
guarantee and the manufacturer's
liability null and void.
Charging the battery
PLEASE NOTE: The new battery does
not come completely charged and
must be charged up to the maximum
before using the appliance for the
first time.
- Charge the battery at room tempera-
ture between 4 and 40ºC.
- Plug the charger (K) into the mains.
- The load indicator (D) will change to
green when the appliance is comple-
tely charged
(The first charging takes approxima-
tely 10 to 12 hours and subsequent
chargings will take about 8 hours.
Never attempt to over-charge the
batteries).
- Connect the charger (K) to the jack
using the socket on the appliance.
The socket is located at the lower/
back part of the appliance.
- A pilot light will come on to indicate
that the charger is ready to begin
charging the battery.
- When the battery is charged dis-
connect the charger from the mains
supply.
NB: For a long battery life, it is
advisable to charge the battery, only,
when it has run out completely.
Manual Ikarus.indb 18
Instructions for use
Before use:
- Before using this product for the
first time, it is important to make a
full charge of batteries.
- Prepare the appliance according to
the function you wish to use.
Insertion of a comb guide:
Fit the comb-guide to the appliance
Use the comb size selector (H) to
adjust the height of the cut
To extract the comb guide, just pull
out.
Use:
- The appliance can be used directly
connected to the mains, or by using
his batteries.
- Unroll the cable completely before
plugging it in.
- Ensure that the electronic connector
is properly attached to the appliance.
- Connect the appliance to the mains.
- Turn the appliance on using the on/
off switch.
- Select the desired cutting height
using the comb height selector (H).
Press it and adjust the height accor-
ding to the desired cutting length.
How to cut the hair:
- Situate the person whose hair you
are going to cut so that the top of
their head is at your eye level.
- To obtain best results is better to
use the appliance on dry hair, as it is
much easier to control the hair and
the result.
- Comb hair well before cutting.
15/04/14 17:35