Sundance Spas maxxus 880 Series Owner's Manual page 58

D. Open/Close Front Panel
Place thumb on front panel release button (7) with forefinger below
front overhang. Press firmly on release button, then flip panel open by
pulling outward at top edge. To close panel, flip panel up and press
firmly until you hear an audible click. Keep the front panel closed at
all times to prevent water intrusion, except when changing discs.
CAuTIoN: never insert wet discs into unit or CD player will be
damaged!
E. Radio Operation
Press source button (4) to select radio mode. Station frequency is
indicated on display.
• To Select Band: press band button (12) to toggle through radio
modes as follows: FM1 - FM2 - FM3 - AM1 - AM2 - FM1. Each radio
band stores up to 6 independent presets, for a total of 18 FM and 12
AM presets.
• To Program Presets: tune in desired radio station, then press and
hold desired preset button for at least 2 seconds.
X=preset number, appears at bottom right of the display. Note:
When power to spa is shut off for any reason, all station presets are
reset.
F. Automatically Setting Station Presets
To automatically set station presets to their next higher stations, press
the preset button (1 to 6) from which to start programming, then press
and hold the auto button (16) for at least 2 seconds. The current
station preset and additional preset memories up to P6 will be
reprogrammed with their next higher tunable stations. When the auto
preset cycle is complete, the unit will remain in preset scan mode and
continue scanning for presets until the auto button (16) is pressed. To
select only the strongest stations, press the local button (10). All 18
FM and 12 AM presets can be set sequentially by selecting the next
band and continuing the operation during auto programming.
g. Seek / Manual Tune
Press tune/seek-up button (13) once to automatically tune the next
higher station. Press tune/seek-down button (14) once to automatically
tune the next lower station. To manually tune to a specific station
frequency, press and hold either tune/seek button for at least 2
seconds. Holding either button down will increase or decrease the
displayed frequency manually. When the desired frequency is reached,
release the button. The unit remains in manual tune mode for 3
Page 54
"PX", where