Sundance Spas maxxus 880 Series Owner's Manual page 55

PooR JET ACTIoN
(see Fig. F-J, page
18-21)
WATER IS Too HoT
No HEAT
CIRCuLATIoN PuMP
oFF
Should checking the above steps fail to correct the problem, please call
your dealer so that he may arrange service.
Sundance builds the best hot tubs in the industry. Nonetheless, we are
always striving to improve the quality and features of our products. Your
input as a Sundance hot tub owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your hot tub, please write to us.
CoNGRATuLATIoNS on your good taste and welcome to the happiest
and most relaxed family in the world!
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 40-41).
1. Reduce thermostat setting (page 16).
2. Switch spa to "Economy" filter mode to
turn heater on only during programmed
filter/heating cycles (page 35).
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If "heater on" indicator is lit (Figure-E,
Page 17), but no temperature rise is
experienced after a reasonable period of
time, contact your dealer or authorized
service center.
1. Verify circulation pump is programmed
to run 24-hours a day (page 37).
2. Circulation pump cycle canceled by power
interruption. Wait 24-hours for hot tub to
reset.
3. Hot tub water is warmer than 95°F (35°C)
and two degrees warmer than the set
temperature. The "Summer Logic" safety
feature has activated. See note on page
35 for details.
Page 51