Sundance Spas maxxus 880 Series Owner's Manual page 20

E. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Dealer. See section titled "WATER QuALITY MAINTENANCE"
(page 44) for general guidance.
F. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow these
steps:
• The LCD display on the control panel displays the actual
temperature of the hot tub water. Press either the CooLER
(Down) or WARMER (up) button once to display the "set"
temperature for 5 seconds. If you want the water to heat to a
different temperature, simply press CooLER or WARMER
within 5 seconds. The set temperature advances or decreases by
one degree each time one of these buttons is pressed.
• The heater will turn off when the temperature corresponding to
the thermostat setting is achieved.
Important Heater Details:
• The maximum temperature for which the hot tub can be set is 104°F
(40°C) and the minimum is 80°F (27°C).
• For Cameo, optima, or Majesta hot tubs powered with a 35 amp
service, turn off jets pump #1 and jets pump #2 to operate heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set
temperature", then turns off. The heater will reactivate after the water
cools to approximately 1.5° below the "set temperature."
g. Place Cover On Hot Tub
• Keeping the insulating cover in place anytime the hot tub is not in use
will reduce the time required for heating, thereby minimizing operating
costs.
• The time required for initial heat-up will vary depending on the starting
water temperature.
DANgER: RISK oF INJuRY. ALWAYS CHECK WATER TEMPERA-
TuRE CAREFuLLY BEFoRE ENTERING HoT TuB.
EXERCISE IN WATER ABoVE 90 DEGREES F (32 °C).
Page 16
Do NoT