Hilti TE 6-CL Original Operating Instructions page 23

7 Types of work
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work
is in progress, immediately disconnect the device and the cord from the electricity supply. Do not touch the
damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
7.1 Forward / reverse
▶ Set the forward / reverse selector switch to forward or reverse rotation.
7.2 Drilling without hammering
▶ Set the function selector switch to the "Drilling without hammering" position
7.3 Drilling with hammer action (hammer drilling)
▶ Set the function selector switch to the "Hammer drilling" position
7.4 Chisel positioning
▶ Set the function selector switch to the "Chisel positioning" position
▶ The chisel can be adjusted to 18 different positions (in 20° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
7.5 Chiseling 6
CAUTION
Risk of injury Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function selector
switch until it engages in the "Chiseling"
▶ Set the function selector switch to the "Chiseling" position
7.6 Removing the accessory tool
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Pull the accessory tool retaining bar back as far as it will go.
2. Remove the accessory tool.
8 Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
*2266070*
5
6
6
position.
4
2266070
6
.
.
.
.
English 17