Getting Started; How To Use - Remington HC600 Manual

ENGLISH

GETTING STARTED

CHARGING YOUR HAIRCLIPPER
Before using your hair clipper for the fi rst time, charge for 14-16 hours.
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains. The charging
indicator will light up.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.

HOW TO USE

Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
To attach a comb
Hold the comb with its teeth upward.
Slide it onto and along the clipper blade until the front of the comb fi rmly sits against the
clipper blade.
To remove the comb
Holding the clipper with the blades facing away from you, fi rmly push the comb upward
and away from the blades.
2
070774_REM_IFU_HC350_RC_innen.in2 2 070774_REM_IFU_HC350_RC_innen.in2 2 10.31.2007 15:33:46 Uhr 10.31.2007 15:33:46 Uhr