Table of Contents
Advertisement
Available languages
Available languages
Trouble or fault
All 4 LEDs flash.
The power tool does not
work.
The power tool or battery
gets very hot.
The power tool does not de-
velop full power.
Diminishing cutting perfor-
mance
The motor has no braking
effect.
10
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r10695219.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Oorspronkelijke handleiding
1
Informatie over documentatie
1.1
Over deze documentatie
•
Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
•
De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
•
De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
22
Nederlands
Possible cause
The power tool has been over-
loaded.
Electrical fault
A battery with inadequate capacity
was used.
Blade and / or cutting rails are
blunt.
Low battery.
The power tool was overloaded
briefly.
Action to be taken
▶ Release the control switch and
then press it again. Then allow
the power tool to run under no
load for approx. 30 seconds.
▶ Switch the power tool off im-
mediately, remove the battery,
keep it under observation, allow
it to cool down and contact Hilti
Service.
▶ Use a battery with adequate
capacity.
▶ Change the blade. → page 20
▶ Change the cutting rails.
→ page 20
▶ Change the battery and charge
the empty battery.
▶ Switch the power tool off and
then on again.
2253583
*2253583*
Advertisement
Table of Contents
