Hilti SSH 6­A22 Original Operating Instructions page 24

SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
Permissible steel 1.5 mm
thickness, steel
up to 400 N⁄mm²
Permissible steel 1.0 mm
thickness, steel
up to 600 N⁄mm²
Permissible ma- 2.0 mm
terial thickness,
aluminum up to
250 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
Starting hole di- 17 mm
ameter
Smallest radius 80 mm
for curved cut-
outs
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
18 English
SSH­CS, SSH­CX,
1.5 ­ 2.5 mm, 0.5 ­ 1.5 mm,
, for , for
straight cuts straight cuts
in stainless
steel
2.5 mm •/•
•/• 1.5 mm
3.0 mm •/•
•/• •/•
•/• •/•
22 mm 20 mm
150 mm 120 mm
SSH­CC, SSH­CD,
0.5 ­ 1.5 mm, 4 x 0.9 mm,
, for curves
ducting
1.5 mm •/•
0.8 mm •/•
2.0 mm •/•
•/• 4 x 0.9 mm
•/• 4 x 0.6 mm
15 mm 18 mm
L 45 mm, 150 mm
R 80 mm
2253583
*2253583*
, for spiral