Hilti SSH 6­A22 Original Operating Instructions page 22

3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held, cordless slitting shear. It is designed for cutting sheet-like workpieces
out of steel, aluminum, plastic or comparable materials. It can be used to cut along a marked line, for cutting
straight or curved outside edges and for cut-outs. The strip of swarf can be cut off at any point on the
workpiece.
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C 4/36 series to charge these batteries.
3.3 Items supplied
Slitting shear, Torx wrench, operating instructions
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your local
Hilti Store or online at: www.hilti.group.
Before being dispatched, the product was tested to ensure that it is in full working order. There
workpiece used in testing might have left tiny scratches in the surface of the housing.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.5 Charge status indicator of the Li-ion battery
The charge status of the Li­ion battery is displayed after one of the two battery release buttons is pressed.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights up.
1 LED flashes.
Indication of the charge status is not possible while the power tool is in operation or immediately
after operation. If the battery charge status LEDs flash, please refer to the information given in the
Troubleshooting section.
16 English
1
Swarf cutter
@
Lockable on/off switch
;
Grip
=
Adjusting knob for speed
%
Dust filter
&
Battery release button
(
Battery
)
Bearing pin
+
Blade
§
Cutter plate
/
Mark for swarf cut-off
:
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
2253583
*2253583*