Troubleshooting - Electrolux AEG CKB400W User Manual

The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
12.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait un‐
til the oven is cold.
Back lamp
Step 1
Step 2
Step 3
Step 4

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
Problem
The oven does not
heat up.
Before you replace the lamp:
Step 1
Disconnect the oven from
Turn the glass cover to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Install the glass cover.
Check if...
The fuse is blown.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Step 2
the mains.
Problem
The Food Sensor
does not operate.
The door gasket is
damaged.
The display shows
"12.00".
ENGLISH
Step 3
Put a cloth on the bottom
of the cavity.
Check if...
The plug of the
Food Sensor is
fully inserted into
the socket.
Do not use the
oven. Contact an
Authorised Service
Centre.
There was a power
cut. Set the time of
day.
27
A