Troubleshooting - Weber 77576 Owner's Manual

Lp gas grill
Hide thumbs Also See for 77576:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Burners burn with a yellow or orange fl ame, in
conjunction with the smell of gas.
Symptoms:
Burners do not light. -or- Burners have a small
fl ickering fl ame in the HIGH position. -or-
Barbecue temperature only reaches 250˚F (121˚C)
to 300˚ F (148˚C) in the HIGH position.
Burner does not light, or fl ame is low in HIGH
position.
Experiencing fl are-ups:
Burner fl ame pattern is erratic. Flame is low when
burner is on HIGH. Flames do not run the whole
length of the burner tube.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.

Troubleshooting

CHECK
Inspect Spider / Insect Screens for possible
obstructions. (Blockage of holes.)
The excess fl ow safety device, which is part of the
barbecue to cylinder connection, may have activated.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the outside burner light with a match?
Are you preheating barbecue in the prescribed
manner?
Are the cooking grates heavily coated with burned-on
grease?
Is the bottom tray "dirty" and not allowing grease to
fl ow into catch pan?
Are burners clean?
The lid is Cast Aluminum, not paint. It cannot "peel".
What you are seeing is baked on grease that has
turned to carbon and is fl aking off.
THIS IS NOT A DEFECT.
CURE
Clean Spider / Insect Screens. (See Section "Annual
Maintenance")
To reset the excess fl ow safety device turn all burner control
knobs and the cylinder valve OFF. Disconnect the regulator from
the cylinder. Turn burner control knobs to HIGH. Wait at least 1
minute. Turn burner control knobs OFF. Reconnect the regulator
to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions".
Refi ll LP cylinder.
Straighten fuel hose.
If you can light the outside burner with a match, then check the
ignition system.
All burners on high for 10 to 15 minutes for preheating.
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q 300Q 300 77576

Table of Contents