Check For Gas Leaks - Weber 42371 Owner's Manual

WARNING : The gas connections of your Summit
gas grill have been factory tested. We do however
recommend that you leak check all gas connections
before operating your Summit
Remove control panel
Part required: Phillips Screwdriver.
Remove the burner control knobs (1). The screws (2) need
to be removed from the control panel (3) before the control
panel is removed from the grill.
(1)
Put your fi ngers under the front edge of the control panel
and lift off.
Completely remove the control panel (4) from the cooking
box assembly exposing the valves, burners, igniter, and
manifold.
(4)
GAS INSTRUCTIONS
®
gas grill.
(2)
(3)
(2)
Remove the Front Panel by sliding the panel up and out of
®
the slots.

CHECK FOR GAS LEAKS

Do not use an open fl ame to check for
gas leaks. Be sure there are no sparks or
open fl ames in the area while you check
for leaks. Sparks or open fl ames will result
in a fi re or explosion, which can cause
serious bodily injury or death and damage
to property.
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fi tting.
Note - All factory-made connections have been thoroughly
checked for gas leaks. The burners have been fl ame-
tested. As a safety precaution however, you should
recheck all fi ttings for leaks before using your Weber Gas
Barbecue. Shipping and handling may loosen or damage a
gas fi tting.
WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or
brush to apply it.
Note - Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the
cylinder valve hand-wheel counterclockwise.
7 7
DANGER