Weber Skyline 3200 Owner's Manual page 20

Step 21
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place from the rear of the barbecue. Close
and align the hinge at the rear. Insert hinge pins from the
outside through the hinge. Insert hair pin cotters into the
small holes in the hinge pins. Figure 27.
Hair pin cotter
Hinge pin
Figure 27
Step 22
Install control panel and burner control knobs
You will need: control panel, two Phillips screws/washers,
a Phillips screwdriver, and three burner control knobs.
Set the control panel in place over both frame braces. (Hold
the Crossover Ignition button up while setting the control
panel in place.) Line up the holes in the control panel with
the holes in the inserts in the frame brace. Insert screws
and tighten with a Phillips screwdriver until snug. Do not
overtighten. Figure 28 (a).
Push on the burner control knobs. Figure 28 (b).
Crossover
Ignition Button
Figure 28
20
Insert in
frame brace
(a)
Control panel
Phillips screws/
washers
(b)