Fujitsu PRIMERGY RX600 S3 SAS Service Supplement Manual page 41

Replacement routines
Figure 21: Removing the system board
Ê Unplug all cables connected to the system board.
Ê Remove the system board as follows:
– Lift the blue button in the middle of the system board (A).
– Holding the button lifted up, slide the system board toward the front of the
housing (B) to be able to lift them out of the fastening elements (C).
– Now lift the system board out of the housing (D), pushing the ventilation
foil attached to the side out of the way.
To install the system board follow the above steps in reverse order.
I
To ensure correct operation, make sure you do the following after
installing the new system board.
– Updating the BIOS firmware
– Setting the BIOS default values
– Adjusting the customer-specific settings
This completes the replacement of the system board.
A
C
Service Supplement RX600 S3 SAS
Replacing the system board
D
B
41