Blow-Sweeping; After Finishing Work; Transporting; Transporting The Blower - Stihl BGA 57 Instruction Manual

English

11.2 Blow-Sweeping

► Point the nozzle at the ground.
► Walk slowly and steadily forwards.

12 After Finishing Work

12.1 After Finishing Work
► Switch off the blower and remove the battery.
► If the blower is wet: Allow the blower to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the blower.
► Clean the battery.

13 Transporting

13.1 Transporting the Blower

► Switch off the blower and remove the battery.
► Carry the blower by the control handle.
► Transporting the blower in a vehicle: Secure the blower to
prevent turnover and movement.

13.2 Transporting the Battery

► Switch off the blower and remove the battery.
42
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets

14 Storing

14.1 Storing the Blower

► Switch off the blower and remove the battery.
► Observe the following points when storing the blower:
– Blower is out of the reach of children.
– Blower is clean and dry.

14.2 Storing the Battery

STIHL recommends that you store the battery with a charge
between 40% and 60% (2 LEDs glow green).
► Observe the following points when storing the battery:
– Battery is out of the reach of children.
– Battery is clean and dry.
– Battery is in an enclosed space.
– Battery is stored separately, away from the blower and
charger.
– Battery is in non-conductive packaging.
– Battery is in a temperature range between -10°C and
+50°C.
12 After Finishing Work
0458-807-9821-A