Air Filter(S) - York D4IC-360 Technical Information

- Indoor fan belts: Check correct condition and tension. If
these are to be replaced, the replacements must be of the
same type and size as the originals (see section No. 10),
and recheck tension within the first 24 operating hours. See
section No. 14 for tensing procedure.
- Air filters: Replace disposable filters, or wash washable
filters. For this purpose, remove the filters from the unit,
sliding them out of their guide rails. The metal frame splits
Air filters
REPLACEMENT OF FILTERING MEDIA
�
LOOSEN MANUALLY, BUT WITHOUT REMOVING, BOTH
FASTENING KNOBS.
�
SLIDE PART
�
PART
�
�
REMOVE THE OLD FILTERING MEDIA AND REPLACE WITH
NEW MEDIA.
IN THE CASE OF DISPOSABLE FILTERING MEDIA, PAY
ATTENTION TO THE MOUNTING POSITION.
�
PROCEED INVERSELY TO REASSEMBLE THE FILTER
ASSEMBLY.
- Indoor coil: A visual inspection is recommended during
the maintenance operation of the filters. The entire surface
of the fins must be kept clean. If cleaning is needed, use a
soft brush or vacuum cleaner, taking care not to damage
�
OUT, UNTIL FULLY SEPARATED FROM
in two without the need of any tools, for easy replacement
of the filtering media.
The disposable filters should be installed in accordance
with the current direction of air flow. To make this op-
eration easier, there is an arrow on the filter frame that
should always point towards the front of the coil. See
Fig. 21.
�
�
- Fig. 21 -
the fins. Never use water hoses inside the compartment.
- Condensed water tray and siphon: Eliminate any dirt or
residues. Make sure the water outlet and the siphon are
not obstructed. Make sure the water discharge and the
�
ATTENTION:
IN THE CASE OF DISPOSABLE
FILTERING MEDIA, THE RIGID
SIDE SHOULD BE ON THE SIDE
INDICATED BY THE ARROW
�
�
���� ������ ��� ���
������ ���������� ���
��������������
FILTERING MEDIA
DIMENSIONS:
990 x 750 x 48mm
(4 UNITS PER UNIT)
9